User guide

 




13
Configuration
Using the configuration menu
The configuration mode allows you to determine numerous aspects of the
AV4PRO-DVI unit capabilities.
To use the configuration menu
During normal use, the seven segment display on the front panel shows the
number of the currently selected computer channel. From this condition, enter
configuration mode as follows:
1 Press and hold the front panel COMPUTER button for roughly five seconds.
The display will show:
2 Onthekeyboard,presstheletterkeyfortherequiredmenusection,e.g.
The display will show the pressed letter, e.g.
3 Press the number of the required setting, e.g.
The display will show the pressed number, e.g.
4 Press to accept the setting and return to the main menu section.
The display will show:
5 Youcannowcontinuewithyournextcongurationchange(gotostep2),
or exit from the configuration menu (see below).
To exit the configuration menu and save changes
• Press and then press to exit and save changes.
To exit the configuration menu without saving
• Presseitherofthefrontpanelbuttons.
Enter the OPTIONS port Baud rate menu
 1200
(default)
 38400
 2400 57600
 9600  115200
 19200
Enter the Functions menu
Show current firmware version
Refresh EDID information from the connected video display
(default)
Use the stored EDID at startup, do not interrogate the video display
Reset configuration to factory defaults ( is displayed momentarily)
Enter the Hotkey menu
 Ctrl+Alt
(default)
Alt
 Ctrl+Shift  LeftCtrl+Alt
 Alt+Shift  RightCtrl+Alt
Right Alt Hotkeys disabled
Enter the Options port behaviour menu
 ChannelswitchingviaRS-232serialcontrol(usingthebaudrateset
bythe‘B’option).ContactswitchingviatheOptionsportdisabled.
(d)
 ChannelswitchingviaRC4remote.Contactswitchingdisabled.
As per but with contact switching enabled.
Set a new password for use with the lock mode
Enter the Switch Mode menu
All
(default)
 KVM+Speaker
KVM only
Speaker only
USB1 only
 USB2only
Enter the Autoscan Time Delay menu
Autoscan disabled 15 seconds
 2seconds 30 seconds
5 seconds
(default)
1 minute
7 seconds 5 minutes
Enter the User Preferences menu
Enable mouse switching
(default)
Disable mouse switching
 Cycleallports(whenusing‘Hotkey+Tab’or‘Autoscan’)
(default)
 Cycleonlyactiveports(whenusing‘Hotkey+Tab’or‘Autoscan’)
 EnableHybridDDCmode(providessupportforDDC/CI)
 DisableHybridDDCmode
(default)
You can press
at any point to exit
from an option and
return to the main
menu ( ) section.
(default)
or
(d)
denote
the default settings
for each group of
options.
HT