Specifications

AdderView MP Installation and Use Page 19
U1 - AdderView MP channels are switchable using a 3 button mouse
or IntelliMouse (default)
(AdderView MP reports 2 button mouse mode to PCs)
U2 - AdderView MP channels are not switchable using 3 button mouse
or IntelliMouse
(AdderView MP reports 2 button mouse mode to PCs)
U3 - AdderView MP channels are not switchable using 3 button mouse
or IntelliMouse
(AdderView MP reports 3 button mouse mode to PCs)
U4 - AdderView MP channels are switchable using 3 button mouse
or IntelliMouse
(AdderView MP reports IntelliMouse mode to PCs)
U5 - AdderView MP channels are not switchable using 3 button mouse
or IntelliMouse
(AdderView MP reports IntelliMouse mode to PCs)
U7 – Cycle between all ports when switching with ‘Hotkeys + Tab’ or three button
mouse (default)
U8 – Cycle between active ports only when switching with ‘Hotkeys + Tab’ or three
button mouse
H1 - Hotkey combination is CTRL + ALT + command key (default)
H2 - Hotkey combination is CTRL + SHIFT + command key
H3 - Hotkey combination is ALT + SHIFT + command key
H4 - Hotkey combination is RIGHT ALT + command key
H5 - Hotkey combination is LEFT ALT + RIGHT ALT + command key
H6 - Hotkey combination is LEFT CTRL + LEFT ALT + command key
H7 - Hotkey combination is RIGHT CTRL + RIGHT ALT + command key
H8 - No hotkey combination enabled
F1 - Display firmware first digit (Note: F1 is FF followed by 11 NOT ll)
F2 - Display firmware second digit
F3 - Display firmware third digit
F5 - Restore PS/2 mouse function
F6 - Restore IntelliMouse function
F8 - RESET all configurations to default settings. (Display confirms with 'r').
P - Sets password - see section 4.6 for instructions.
E - Exits configure mode and returns the AdderView MP to normal operation mode.