User guide

 




15
RX video display
ALIF units support DVI digital
video signals and so use DVI-D
video connectors throughout.
• ALIF1000modelscansupport
a single high resolution DVI-D
video display at pixel clocks up
to165MHz(equatingtoan
exampledisplaymodeof1920
x1200at60Hzrefresh).
• ALIF2000modelscansimultaneouslysupportuptotwohighresolution
videodisplaysatpixelclocksupto165MHz;orcanalternativelysupportone
veryhighresolutionvideodisplay(atpixelclocksupto330MHz).
To connect a digital DVI video display
1 ConnecttheleadfromthevideodisplaytotheDVI-Dsocketontherear
panel of the ALIF unit.
DVI-D
To video display
VSCD3 cable to primary
video display
[ALIF2000whenusingoneveryhigh
resolution DVI-D dual link display]
Use a DVI-D Dual Link cable (such
as Adder part: VSCD3) to connect
thevideodisplaytotheDVI-D-1
connectoroftheALIF2000RXunit.
A dual link cable must also be used at
the TX unit.
WhenusingduallinkonDVI-D-1,the
DVI-D-2portwillbedisabled.
IfDVI-D-2isalreadybeingused,then
it must be disconnected before dual
linkoperationcanoccuronDVI-D-1.
To primary video display
To secondary video display
[ALIF2000whenusingtwosinglelink
DVI-D displays] Connect an additional
video input from the secondary video
port of the computer system using
the supplied secondary DVI-D link
cable.
DVI-D-2
DVI-D-1
USER CONSOLE
DVI-D-2
DVI-D-1
USER CONSOLE
[ALIF1000]
ALIF TX
LINK
ALIF RX
VIDEO
DISPLAY
USB
DEVICES
MIC &
SPEAKERS
POWER
IN
SERIAL
LINK