User guide

INSTALLATIONCONFIGURATIONOPERATION

FURTHER

INFORMATION

INDEX

AdderLink Innity browser-based conguration utility

The browser-based conguration utility within all TX and RX units requires a network

connection between the Gigabit Ethernet port of the ALIF 2112T unit and a computer

on the same network. The conguration utility allows you to perform all of the following

functions:

• View/edit the IP network address and netmask,

• Congure separate IP network addresses for video, audio and USB,

• Congure multicast settings (on RX units),

• Congure video bandwidth settings (on TX units),

• View the current video output (on TX units),

• Perform a rmware upgrade,

• Perform a factory reset,

• Enable/disable and congure the VNC network port settings.

To connect a computer system for browser-based conguration

1 Connect a suitable network cable to the Gigabit Ethernet port on the right side of the

ALIF 2112T front panel.

Note: It is also possible to gain access to the browser-based utility via the Teaming port.

2 Connect the other end of the link cable to your network.

3 Similarly, link your computer to the same network.

4 If not already switched on, power up your computer and the ALIF 2112T unit. You are

now ready to use the browser-based conguration utility.

To access the browser-based conguration utility

1 Temporarily connect the ALIF 2112T unit and your computer, as discussed left.

2 Run a web browser on your computer and enter the IP address of the ALIF dual port

that you are using.

The default settings are as follows:

ALIF 2112T RX units

System port 169.254.1.33 169.254.1.32

Teaming port 169.254.1.43 169.254.1.42

Note: Where the port addresses of a unit have been changed and are not known, providing it

is appropriate to do so, perform a manual factory reset to restore the default addresses.

The opening page of the ALIF conguration utility should be displayed:

You can nd further information about the conguration pages within the following

appendix later in this guide:

• Appendix A - Transmitter (TX) unit conguration pages

Use the menu options to choose

the required conguration page

www.adder.com

Link from Ethernet

switch to the System

(Gigabit Ethernet) port

on the right side of the

front panel