User guide

 




11
Computer system (via CAM)
Each computer system is connected to the
AdderView CATxIP 1000 unit via a Computer
Access Module (CAM) and standard category 5,
5e or 6 cabling. CAMs are available in various
formats to suit differing computer system types
and their particular connector styles.
Each CAM uses Adder Keep Alive technology
to ensure that the keyboard and mouse inputs
to the computer remain active, even when
the particular channel is not selected. This action ensures that there are no
connection delays or problems as the port is selected.
To connect a computer system
1 Ensure that power is disconnected from the AdderView CATxIP 1000 unit
and the system to be connected.
2 Locate the required CAM (there are five types available) and attach its video,
keyboard and mouse (PS/2-style, USB or Sun) to the relevant sockets on the
computer system.
3 Lay a suitable length of category 5, 5e or 6 cabling between the computer
system and the AdderView CATxIP 1000 unit. The maximum length of the
cable can be up to 10 metres (32 feet), however, bear in mind that the
overall distance between a remote user and any computer must not exceed
300 metres (980 feet).
4 Attach the connector of the cable
run to the socket of the CAM.
5 At the other end of the cable run, attach the cable connector to one of the
sockets labelled COMPUTER CONNECTIONS on the rear panel of the AdderView
CATxIP 1000 unit.
Video
PS/2-style mouse
PS/2-style keyboard
Audio
USB keyboard/mouse
Sun keyboard/mouse
A range of different
connector combinations
are made available
across the five CAM
formats
Computer
Access
Module
Category 5, 5e or 6
cable from CAM
Category 5, 5e or 6
cable to AdderView
CATxIP 1000
AdderView CATxIP
1000 rear panel
Green indicator - power present
Yellow indicator - signal activity
Note: CAMs derive power from the
computer system via either the PS/2-style
keyboard connector, USB or SUN connector.
GLOBAL
USER
IP
LOCAL
USER
POWER
IN
POWER
SWITCH
COMPUTER
SYSTEM
CAM
Note: Each CAM is
specifically shaped so
that it can be secured
using a cable tie around
its middle. In this way,
two CAMs can also be
neatly joined together,
back-to-back.