User guide

 




13
Power connection
Each AdderLink XD522 unit is supplied with a 20W power adaptor. There is no
on/off switch on the unit, so operation begins as soon as a power adaptor is
connected.
To connect the power supply
1 Attach the output lead from the power adaptor
to the 5V socket on the rear panel of the unit.
Note: Both the unit and its power supply generate heat when in operation and
will become warm to the touch. Do not enclose them or place them in locations
where air cannot circulate to cool the equipment. Do not operate the equipment
in ambient temperatures exceeding 40 degrees Centigrade. Do not place the
products in contact with equipment whose surface temperature exceeds 40
degrees Centigrade.
3 Connect the power lead to a nearby mains supply socket.
2 Connect the IEC connector of the supplied country-specific power lead to
the socket of the power adaptor.