User guide

welcome contents
installation
&operation
special
configuration
furter
information
7
Operation
General use
In use, the local device and X100 receiver should be transparent - the system
and its peripherals should operate exactly as normal, the only difference being
that they are now 100 metres or more apart.
In some installations, you may see some ‘shadows’ to the right of high contrast
screen characters. This can be caused by an incorrectly selected sharpness setting
and it may be necessary to make adjustments to correct this. Please see Video
compensation - sharpness and brightness in the ‘Special configuration’
section.
Locking and unlocking the system
In situations where the computer system (and the local device) can be locked
away, the X100 receiver offers a viable security system to deter unauthorised
use. Once a password has been set, a simple key sequence allows the system to
be quickly and securely detached from its peripherals. Only the correct password
will reconnect the X100 receiver with the local device.
To lock the system
1 First set a password. For further details, please refer to the
Password
setting section in the ‘Special configuration’ chapter.
2 Simultaneously press the currently configured hotkeys (by default, and
) along with .
The screen will go blank and the three keyboard
indicators will begin alternately flashing between the
‘Num Lock’ and ‘Scroll Lock’, and ‘Caps Lock’. This
sequence indicates that a password is required.
To unlock the system
1 Enter the correct password and press
.
Note: Passwords are NOT case sensitive.
Note: If an invalid password has been entered and the keyboard indicators
are not flashing as described above, press to clear the incorrect attempt.
2 If the correct password is entered, the screen will be restored and normal
operation can continue.
To enable the video
Simultaneously press the currently configured hotkeys (by default, and )
long with . This command will be required to restore the video if and
along with is used when no password has been set.
To disable the video
Simultaneously, press the currently configured hotkeys (by default, and )
along with .
Num
Lock
Caps
Lock
Scroll
Loc
k