User guide

5
CONTENTSINTRODUCTIONINSTALLATIONOPERATION
FURTHER
INFORMATION
Installation
CONNECTIONS
Installation of the X-DVIPRO-DL modules is straightforward and requires minimal
congurationinmostcases.
• Connections at the local module
• Connections at the remote module
Note: After all connections have been made, power up the display screen and the remote
module rst. Then power up the local module and nally switch on the computer. This will allow
each item to correctly discover, in order, the one immediately downstream.
Mounting the modules – desk or rack
The X-DVIPRO-DL modules can be situated on a desk or alternatively, for larger
installations, mounted within an optional rack mount chassis.
Desk mount
Apply the supplied self-adhesive rubber feet to
the underside of the module.
Rack mount
1 Place the rack securing plate (available as a separate kit) onto the front of the module
and secure it with the two countersunk screws.
2 Orient the X-DVIPRO-DL module on its side so that its labeled face is the correct
way up.
3 Slide the module into the required rack position. The rectangular cut-out in the front
upper lip of the rack allows the two screws on the module’s upper edge to slide
through.
4 Therackmountchassishasaseriesofholesinitsoorthatare
spaced to accommodate the two screws on the module’s
lower edge. Ensure that the screws correctly locate
into the two holes of the chosen slot. The rack
securing plate on the module should now be
ushwiththefrontoftherackmount
chassis.
5 Use the third (pan-head)
screw, in the top hole
of the rack securing
plate to fasten the
module to the rack.
HT