Specifications


F




6
Connections at the remote module
Video connection
1 Connect the DVI/D lead from the video monitor to the DVI output socket of
the remote module.
LINK
TO
LOCAL
ON
USB connection
1 Connect the leads from the keyboard and mouse to the two USB sockets on
the remote module.
REMO
TE
ADD
UPG
Link connection
1 Attach one of the supplied ferrite cores to the link cable, next to the
connector. This is necessary to ensure compliance with the European EMC
directive and FCC regulations.
2 Connect the link cable (see page 2 for cable advice) to the remote module
socket labelled TO LOCAL.
3 If necessary, use video compensation to overcome the effects of long cable
lengths on the video signal - see page 7 for details.
Power connection
1 Connect the output lead of the
supplied power adapter to the
socket labelled ‘POWER‘ on the
remote module.
2 Insert the IEC connector of
the separate power lead
into the corresponding
socket of the power
adapter. Connect the
other end of the power
lead to a nearby mains
socket.
REMO
TE
ADD
UPG
Type-A USB connectors
from the keyboard and
mouse
DVI/D connector
from the monitor
Output lead from
the power adapter
LINK
TO
LOCAL
ON
RJ-45 connector of
the CATx link cable
Supplied ferrite core
3 After all connections
are made, power up
the remote module
and then switch on the
computer.
See the INSTALLATION ADVICE on page 4