User guide

 




23
Resetting the Digital iPEPS to factory default
For situations where the IP address or the password has been forgotten, or the
Digital iPEPS is being reinstalled, it is possible to reset the unit to its original
factory settings. This erases all configuration such as hosts, users and passwords,
and restores the default network address.
To perform a factory reset:
1 Disconnect the power, USB and video cables from the Digital iPEPS unit.
Leave the network cable plugged in and use it to link the Digital iPEPS unit
to a network.
2 Set Configuration Switch 2 to the ON (up) position.
3 Apply power to the unit (either from the power supply or via both USB
cables).
4 Leave Switch 2 in the ON (up) position until the orange indicator illuminates,
at which point, immediately set Switch 2 to the OFF (down) position.
If the factory reset is successful, the orange indicator will flash off once after
fifteen seconds.
After the factory reset is complete, the unit will reboot and you can connect
a VNC viewer to it using the default IP address: 192.168.1.42 to check that
the configuration has been reset.
Note: If the factory reset is unsuccessful, power down the Digital iPEPS unit and
try again.