User guide

 


16

RECEIVER
200
ADDERLINK
OUT
OUT
To connect the power supply
NOTE: Please read and adhere to the electrical safety information given within
the Safety information section of this guide. In particular, do not use an
unearthed power socket or extension cable.
1 Attach the output connector of the power supply to the
socket labelled POWER on the AdderLink AV receiver.
2 InserttheIECconnectorofthepowercableinto
the corresponding socket of the power
supply.
3 When all other connections have
been made at the transmitter
and receiver modules,
connect the other end of
the power cable to a nearby
earthed mains socket.
RECEIVER
200
ADDERLINK
OUT
OUT
To connect the serial port
The AV200R/AV201R receivers provide a single RS232 serial socket for use with
display control circuitry, etc. Where two connected displays both require serial
control, a special Y-cable is available (Adder part number: VSC19).
Note: The Y-cable is supported only when the AV200R/AV201R receiver is linked
to an AV204T or AV208T transmitter. If the receiver is linked to an AV200T
transmitter, only a single display may be connected to the serial connector of the
AV200R/AV201R receiver.
1 Attach the female connector of the Y-cable or serial device link cable to the
socket labelled on the AdderLink AV200R/AV201R receiver.
2 Attach the other end of the serial cable (or both ends
of the Y-cable) to the appropriate RS232 control
socket(s) of the display(s).
Note: The two male connectors of
Y-cable are labelled A and B.
These labels are important
and identify each
display for port
switching purposes.
Important
AdderLink AV200 transmitters and
receivers are supplied with power
adapters which provide a slightly
different voltage to those used with
other Adder products. Although
the AV200 power adapters appear
to be physically identical, they are
labelled as 5.3VDC (rather than the
usual 5VDC). Using a standard Adder
5VDC power supply will not cause
damage but will affect sound quality.
Important
• ItisessentialthatthesourcePC,allAV204T/AV208Tmodulesandall
connected displays are configured to use the same serial communication
settings (see Switch settings for details). The AV200T, AV200R and AV201R
modules all auto-sense the serial configuration and do not have switches.
• WhenswitchesSW2toSW10areallOFF,theAVmoduleissettoexpectthe
following serial port configuration: 19200 baud, 8-bit data byte, 1 stop bit,
no parity checking, software handshake.