User guide

 


12

ADDER
®
TRANSMITTER
LINK 5 LINK 6 LINK 7 LINK 8
LINK 1
POWER
LINK 2 LINK 3 LINK 4
www.adder.com
208
OU T
IN
IN
IN
ADDERLINK
OU T
OU T
To connect the source computer serial port
Note: The serial port feature supports RS232 serial devices at speeds up to
19200 baud and all hardware handshake lines are available (AV200T, AV200R &
AV201R only). No extra error checking on the serial port signals is applied.
1 Attach the male connector of the supplied serial link cable to the socket
labelled on the AdderLink AV200T transmitter or IN on the
AdderLink AV204T/AV208T transmitters.
2 Attach the other end (female connector) of the serial cable to the
appropriate RS232 serial socket on the source PC system.
TRANSMITTER
200
ADDERLINK
IN
IN
Connecting the source computer
serial port to the AV204 or AV208
transmitter
Connecting the source computer
serial port to the AV200 transmitter
Important
• ItisessentialthatthesourcePC,all
AV204T/AV208T modules and all
connected displays are configured to use
the same serial communication settings (see
Switch settings for details). The AV200T,
AV200R and AV201R modules all auto-
sense the serial configuration and do not
need to be set.
• WhenswitchesSW2toSW10areall
OFF,theAVmoduleissettoexpectthe
following serial port configuration: 19200
baud, 8-bit data byte, 1 stop bit, no parity
checking, software handshake.
• Remembertosettheswitchesbefore
power is applied to the unit.