User guide

25
INSTALLATIONCONFIGURATIONOPERATION
FURTHER
INFORMATION
INDEX
THE TRANSMITTERS TAB
The Transmitters tab shows a paginated table of all transmitter devices within the A.I.M.
network.
Click the TRANSMITTERS tab to view the transmitters page.
Transmitters > View Transmitters
The table shows the following information for each receiver:
• Name • Online status
• IP address • Firmware revision of transmitter
• Channels (attributed to each transmitter) • Description & Location
• Manage (admin options - see below)
The Manage icons are as follows:
(Note: You can hover your mouse pointer over any icons to reveal additional information):
Congure device: Displays the “Congure Transmitter” page.
Reboot device: Allows you to reboot or reset a unit to its factory settings. A
popup will ask which task you wish to carry out. A reboot is useful if a device enters
an unknown state. A reset will return the unit to its factory default state and reset
its IP address (the unit will retain any rmware updates that have been applied).
Identify unit: Causes the LED lights to ash on the front of the selected unit. An
alert will be shown if the unit cannot be contacted (e.g. if it is ofine).
Delete device: Conrmation will be requested. You will need to factory-reset any
devices that you wish to re-congure to work with A.I.M.
Search lters
The key elds (Name, Description and Location) all provide a
search lter to locate particular items within long lists. Enter a full
or partial search string into the appropriate lter box and then
click to start the search. Optionally use the buttons to
invert the order of the listing.
The page will reload with the same pagination/sort order, but with the added search
lter. It’s possible to lter by several columns at once (e.g. search for all entries with
“mac” in the name, and “mixed” in the description). Search terms are case-insensitive.
You can re-sort and paginate on ltered results without losing the lters.
To remove a lter, click the red cross next to the relevant lter, (you can also empty the
search box and click again).