Owner's Manual
2021-Current Ford Bronco ADD Stealth Fighter ™
Rear Bumper Installation Instructions
Addictive Desert Designs® | Page 5
®
ADDICTIVE DESERT DESIGNSADDICTIVE DESERT DESIGNS®®
7. Aer the Sensor bezels have been installed you can transfer the wiring harness from the OEM bumper to the
ADD bumper. You will notice that one inner sensor will not reach the bezel destination, you will need to open up
the wiring harness by cutting it to get enough length to plug in the sensor in place. Aer the achieve the correct
length then tape back up like it was from the factory. (Fig G)
Fig GFig G
Tape back up
Cut
harness back