Datasheet

AddOn Computer Phone: [phone]
Page 7 of 10
BN-CKM-SP-SR-AO
BLADE, 10GBASE-SR SFP+ MMF
850NM 300M REACH LC
OMA, PRBS 2
31
-1, BER
< 1*10-12@8GBd
-11.2
OMA, PRBS 2
31
-1, BER
< 1*10-12@10GBd
-11.1
OMA, PRBS 2
31
-1, BER
< 1*10-12@1.25GBd
tbd
Stressed Receiver
Sensitivity Ethernet
Pavg, PRBS 231-1,
BER < 1*10-12@
10.3125GBd
PIN
-7.5
dBm
OMA, PRBS 2
31
-1, BER
< 1*10-12@2GBd
-10.8
OMA, PRBS 2
31
-1, BER
< 1*10-12@4GBd
-9.0
OMA, PRBS 2
31
-1, BER
< 1*10-12@8GBd
PIN
-8.3
dBm
Stressed Receiver
Sensitivity Fiber
Channel (OM3
fibers)
OMA, PRBS 2
31
-1, BER
< 1*10-
12@10.3125GBd
-17.5
Pav_as
-30
POMA_deas
-12
Loss of Signal
Ethernet:1.25GBd *)
Pav_deas
-17
dBm
Digital Optical Monitoring
Transceivers offer the ability to monitor important module parameter during operation.
The five parameters listed below are continuously monitored for getting information
about the current module status. All data is calibrated internally; there is no need for
external post processing.
Temperature
Internally measured temperature data is represented as two’s complement of a signed
16-bit value in increments of 1/256 °C over a range of -40 to +100°C. Accuracy is better
than +/-3%.
Supply Voltage (VCC)
Internally measured supply voltage. Represented as a 16-bit unsigned integer with the
voltage defined as the full 16 bit value (0 – 65535) with LSB equal to 100 µVolt, which
yields to a total range of 0 to +6.55 Volts. Accuracy is better than +/-3%.
Laser Bias Current
VCSEL bias current. Represented as a 16 bit unsigned integer with the current defined
as the full 16-bit value (0 – 65535) with LSB equal to 2 µA, valid range is 0 to 20 mA.
Accuracy is better than +/-10%.
Optical Transmitter Power
TX output power measurement is based on internal monitor diode feedback.
Represented as a 16-bit unsigned integer with the power defined as the full 16 bit value