Installation Manual

Instollelion continued.
MOTOR WILL OPERATE IMMEMATELY WRING STEP 6. FIRST, READ ALL INSTRUCTIONS INSIDE lWlS BOX
IMPORTANT TIP
D WINDOW COVEWNG MUST BE APPROXlMATELY HALF WEN.
ID WNww COVERIN6 CORD SUGM1Y TO MODERATELY TAUT ( NOT VERY TAUT j-
6D BOTH ACTUATORS MUST BE SET CLOX TO STOP MCH 2C.
D CHILD
SHIELD MUST BE INSTALLED OTHERWISE MOTOR WILL NOT RUN.
6. RUG ADAPTER IWO ELECTC(IC WALL OWLET. BE
TO UNPLUG ADAPTER
If window covwlng reaches dedred posilion IMMEDIATELY UNPLUG Adapter. Thon do tho fdtourlng.
0 Mmuaity mom Stop Swllch 2ctmm b pwenl pilbn to tho oppadte slde. DO NOT MOVE lT BACK.
0 It you move the Switch Id,
4 (h6n date TlPPEWduala~ h until it &JI& Iho Swikh.
0 If you mw~ the Switch right, -). I& tolale FIAT-ActuWP W it lour9ms Ihe Swilch.
If maw MopQ
whlew covering reaches &sirad mliton, do tho Mlovulng.
a ~~~dstjneetodesi~pitian,divicletya ~~mplc:~tyxe-~~~ OMCL~~=~.
O
Roue *conlmfinym AduWor 8dScks &&J h Ute he. 'Canlrdliiy* AcluatOr will bc W the Svrlch.
b-1 Ncvcr dl~w motor 10 run aht window c(l~fillg b
OpCn W Chsd. If
~~, ma( limit
is roached or cord is Loo taut $dm Actustore to prawnt overrun. MOnlt~#aOjud pwiodicaUy.
REQUIRED ADJUSTMENT
7, IF ANY STOP POSITION CHANGES, PROMPT ADJUSTMENT IS NEEDED TO AVO10 DAMAGE.
AFTER COMPLETING
D If window COVCDII~ h0.l to close fully: Move Cld Pas'nion Actuator 1 or mar ddu
STEP 6 ABOVE
from the Slop Switch. And move the opposite Actuator the same number of cllck
to the Stop Switch to prevent over-lravel in Open Position.
0 If window covering om-travek: Move Actuator 1 a more clicks closer to Stop Switch.
1
I Check far cord stock. Lower mOIor one notch on wall bracket il needed.
Do not l-.
I
/ It is nand for window -ring cord to saetch in days or ~eek8 mat37 molor installation, This can
cause window covering stop posit)ons to chonge. Periodidly obsenre window covering.
REMOTE CONTROL