Owner's Manual

LUBRICATION
Upper Receiver Group
Apply one drop of CLP to the forward assist, ejection port door latch, and the ejection port door spring.
Bolt Carrier Assembly
Put a light coating of CLP on all surfaces of the bolt carrier group and then wipe off excess.
Lower Receiver Group
Apply one drop of CLP on the action springs, pins, detents, pivot pin and takedown pin.
ASSEMBLY
The bolt carrier assembly is reassembled in reverse order. Install the rear charging handle and bolt
carrier assembly into the upper receiver. Install the buffer and buffer spring. The front piston assembly is
reassembled in reverse order as is the lower rail. Make sure the selector is on SAFE. Place the upper and
lower receivers together and push in the pivot pin and the takedown pin.
AFTER RE-ASSEMBLING THE RIFLE, ALWAYS PERFORM
A SAFETY/FUNCTION CHECK
1. Point the rifle in a safe direction.
2. Set the selector lever to “SAFE” position.
3. Remove the magazine and clear the rifle chamber. Be certain there is no ammunition in the chamber.
4. Pull the charging handle (either the rear charging handle or the forward charging handle) backward
and release the handle.
5. Pull the trigger. The rifle’s hammer should not fall.
6. Release the trigger.
7. Set the selector lever to “SEMI” position.
8. Slowly pull back on the trigger and hold it. You should hear the hammer fall.
9. With the trigger pulled back, pull and release the charging handle while letting the trigger slowly
move forward. You should hear an audible click, but the hammer should not fall.
10. Repeat this process several times.



26 27