Owner's Manual




1) Push the upper portion of the bolt catch to release the bolt carrier forward.
2) Place the selector on SAFE.
3) Push in the rear takedown pin and the front pivot pin to separate
the upper and lower receivers.
4) Pull the rear charging handle to the rear of the upper receiver.
NOTE: The bolt carrier will move with the charging handle.
Remove the bolt carrier assembly and then remove the rear charging handle
by pulling down and to the rear. (Photograph 1 and 2 )
Using a punch, remove the firing pin retaining pin from the bolt carrier by lifting it outward.
Remove the firing pin from the bolt carrier by tapping the open end of the carrier on the palm of your hand.
(Photograph 1)
Next, push bolt back into carrier (locked position) until the cam pin moves to rear position.
Once the bolt is in locked position, turn the cam pin 90 degrees and remove. (Photograph 2)
Photograph 1 Photograph 2
Inspect the Dust Wiper located
on the side of the Bolt Carrier.
If the springs behind the dust wiper
require replacement, the wiper can
be pried from the retaining lugs.
The wiper system should then be
replaced in its entirety.
Photograph 1 Photograph 2
CAM PIN
18 19


 