User guide

16
addVANTAGE Pro 6.2 User Guide CHAPTER 2
Navigating the Data
2. Select Change values manually to display the dialog shown in Figure 8.
Figure 8. Change Values Manually Dialog
Target shows which value you selected to change.
3. Click the down arrow next to Source to choose what you want to do:
• Copy values from another tag
Select this when you know another tag has the correct values and you
want to copy them to the current tag. Continue with step 4.
• Mark values as BAD
Select this to mark a range of values as incorrect. Skip to step 7.
• Remove manual values
Select this to replace manual values with automatic values for a range.
Skip to step 7.
4. Click the Source field to display a Tag Chooser dialog similar to the one
shown in Figure 9.
Figure 9. Tag Chooser Dialog
5. Click the appropriate station in the left pane, then select the tag with values
you want to copy in the right pane.
6. Click OK to return to the Change Values Manually dialog.
7. Enter the Start time and End time for the values to copy, mark as bad, or
remove.
8. Click OK.
If you copied values from another tag, you’ll see that where the values for
both sensors are the same, the old are overwritten by the new.
View Data
Open a Trend panel to see data from the node’s children.
Show on Map
View the location of the selected RTU on a map.
Properties
View and edit node-specific information.