User's Manual
Table Of Contents
- Objective
- Module introduction
- Basic Operation
- General
- "Hayes" Mode
- "Point-to-Point" Mode
- "Network" Mode
- Demo Kit Utilization
- Installation and Connection
- WinB900 Software Utilization in Point-to-Point Mode
- The different fields and buttons are described below:
- "Sent Characters" Field
- "Received Characters" Field
- "Test Frames" Selection
- "Characters Count" Field
- Button: "Send"
- Button: "Continuous"
- Button: "Initialization"
- Button: "Stop"
- Button: "Quit"
- "Character Count Sent/Received" Fields
- "Elapsed time" Field
- "Sent/Received/Corrupted Count" Fields
- "Stop on Error" Selection
- Use of the WinB900 Software in Network Mode
- Use of the "Terminal" or "HyperTerminal" Software
- Advanced Operation
- Appendix 1: Schematic Block Diagram
- Appendix 2: Mechanical Drawings
- Appendix 3: Antenna Connection
- A
- Appendix 5: Timing Diagrams
- Appendix 6: Description of the registers
- Appendix 7: Revisions History
46
Appendix 7: Revisions History
Appendix 7: Revisions HistoryAppendix 7: Revisions History
Appendix 7: Revisions History
No. of
No. of No. of
No. of
Revision
RevisionRevision
Revision
Date
DateDate
Date
Author
AuthorAuthor
Author
Subject
SubjectSubject
Subject
0.0 01/08/00 GS Document Creation
0.1 08/08/00 GS Modifications after YN reading.
0.2 28/08/00 GS Addition of Network Specifications. Serial configuration MAJ.
0.3 10/10/00 SP English Text, Diagrams and Clarifications
0.4 1/26/01 SP Added FCC Disclaimers (Pages 6 & 16)
0.5 1/31/01 SP Changed Channel Spacing from 200 kHz to 150 kHz (Page 6)
0.6 4/20/01 SP Consolidated FCC Disclaimers to Page 5 and various other
miscellaneous corrections.
0.7 8/7/01 SP Added RF safety warning and removed antenna information per
FCC request