User's Manual
Table Of Contents
- Objective
- Module introduction
- Basic Operation
- General
- "Hayes" Mode
- "Point-to-Point" Mode
- "Network" Mode
- Demo Kit Utilization
- Installation and Connection
- WinB900 Software Utilization in Point-to-Point Mode
- The different fields and buttons are described below:
- "Sent Characters" Field
- "Received Characters" Field
- "Test Frames" Selection
- "Characters Count" Field
- Button: "Send"
- Button: "Continuous"
- Button: "Initialization"
- Button: "Stop"
- Button: "Quit"
- "Character Count Sent/Received" Fields
- "Elapsed time" Field
- "Sent/Received/Corrupted Count" Fields
- "Stop on Error" Selection
- Use of the WinB900 Software in Network Mode
- Use of the "Terminal" or "HyperTerminal" Software
- Advanced Operation
- Appendix 1: Schematic Block Diagram
- Appendix 2: Mechanical Drawings
- Appendix 3: Antenna Connection
- A
- Appendix 5: Timing Diagrams
- Appendix 6: Description of the registers
- Appendix 7: Revisions History
41
Appendix 5: Timing Diagrams
Appendix 5: Timing DiagramsAppendix 5: Timing Diagrams
Appendix 5: Timing Diagrams
The user sends data
TxD
RTS
Radio
Ack_Tx
Lock
Serial Data
Radio Transmission
Result: Error
TimeOut
Serial Data
Radio Transmission
Result: OK
Serial Data
Radio
Stop on CTS,
Len
g
th ≥ S215
Stop on TimeOut
Len
g
th<S215
If Slave, Master/Slave synchronization just ended correctly.
Active
active
inactive
inactive