User's Manual
Table Of Contents
- Objective
- Module introduction
- Basic Operation
- General
- "Hayes" Mode
- "Point-to-Point" Mode
- "Network" Mode
- Demo Kit Utilization
- Installation and Connection
- WinB900 Software Utilization in Point-to-Point Mode
- The different fields and buttons are described below:
- "Sent Characters" Field
- "Received Characters" Field
- "Test Frames" Selection
- "Characters Count" Field
- Button: "Send"
- Button: "Continuous"
- Button: "Initialization"
- Button: "Stop"
- Button: "Quit"
- "Character Count Sent/Received" Fields
- "Elapsed time" Field
- "Sent/Received/Corrupted Count" Fields
- "Stop on Error" Selection
- Use of the WinB900 Software in Network Mode
- Use of the "Terminal" or "HyperTerminal" Software
- Advanced Operation
- Appendix 1: Schematic Block Diagram
- Appendix 2: Mechanical Drawings
- Appendix 3: Antenna Connection
- A
- Appendix 5: Timing Diagrams
- Appendix 6: Description of the registers
- Appendix 7: Revisions History
39
Appendix 4: D900SS
Appendix 4: D900SSAppendix 4: D900SS
Appendix 4: D900SS-
--
-20 Demo Kit
20 Demo Kit20 Demo Kit
20 Demo Kit
Composition
The D900SS-20 Demo Kit is used to test with ease the B900ss-20 radio module.
For this purpose, this kit connects a radio module to a serial interface in order to be
able to work with the radio module without having to develop a specific interface.
In addition, Windows configuration and test software is included with the kit and allows
working with the radio module immediately.
In a case, each D900SS-20 Demo Kit includes:
• Two metallic plates, with:
$ 2 900 MHz antenna,
$ 2 B900ss-20 radio module,
$ 2 interface cards connecting B900ss-20 and RS232,
• Two power supplies
• Two 9V batteries, allowing to manage without sector during field tests,
• A CD-ROM including this document in PDF Format and the "WinB900" Test and
Configuration Software for Windows.
B900SS-20
Radio Module
Radio Antenna
RS232
Version 1 Interface
Card
On/Off Switch
8-24V Power Supply Jack
9 pin RS232 Sub-D Connector