User's Manual

34
Appendix 2: Mechanical Drawings
Appendix 2: Mechanical DrawingsAppendix 2: Mechanical Drawings
Appendix 2: Mechanical Drawings
Drawing of the B900ss-20 Card
WARNING :
WARNING :WARNING :
WARNING : In the "Rev. A" version of the card, the 1° connector contact of the J1 interface
In the "Rev. A" version of the card, the 1° connector contact of the J1 interface In the "Rev. A" version of the card, the 1° connector contact of the J1 interface
In the "Rev. A" version of the card, the 1° connector contact of the J1 interface
(corresponding to the RTS Signal) is "below", as shown on the schematic.
(corresponding to the RTS Signal) is "below", as shown on the schematic. (corresponding to the RTS Signal) is "below", as shown on the schematic.
(corresponding to the RTS Signal) is "below", as shown on the schematic.
In future ("Rev. B, Rev C, etc.” versions, the 1° connector contact of the J1 interface
In future ("Rev. B, Rev C, etc.” versions, the 1° connector contact of the J1 interface In future ("Rev. B, Rev C, etc.” versions, the 1° connector contact of the J1 interface
In future ("Rev. B, Rev C, etc.” versions, the 1° connector contact of the J1 interface
(corresponding to the RTS Signal) will be "above", meaning on the opposite side of its actual
(corresponding to the RTS Signal) will be "above", meaning on the opposite side of its actual (corresponding to the RTS Signal) will be "above", meaning on the opposite side of its actual
(corresponding to the RTS Signal) will be "above", meaning on the opposite side of its actual
position.
position.position.
position.
1.71"
1.57"
Interface Connector
(14FMS-1.0SP-TF
)
Ground Antenna
(Cold Point)
Antenna Hot Point
1° Connector Contact
(RTS)