User's Manual
Table Of Contents
- Objective
- Module introduction
- Basic Operation
- General
- "Hayes" Mode
- "Point-to-Point" Mode
- "Network" Mode
- Demo Kit Utilization
- Installation and Connection
- WinB900 Software Utilization in Point-to-Point Mode
- The different fields and buttons are described below:
- "Sent Characters" Field
- "Received Characters" Field
- "Test Frames" Selection
- "Characters Count" Field
- Button: "Send"
- Button: "Continuous"
- Button: "Initialization"
- Button: "Stop"
- Button: "Quit"
- "Character Count Sent/Received" Fields
- "Elapsed time" Field
- "Sent/Received/Corrupted Count" Fields
- "Stop on Error" Selection
- Use of the WinB900 Software in Network Mode
- Use of the "Terminal" or "HyperTerminal" Software
- Advanced Operation
- Appendix 1: Schematic Block Diagram
- Appendix 2: Mechanical Drawings
- Appendix 3: Antenna Connection
- A
- Appendix 5: Timing Diagrams
- Appendix 6: Description of the registers
- Appendix 7: Revisions History
17
• "Characters Count" Field
This field allows the selection of the character count to be sent if the selected test
frame type is any other than "free".
• Button: "Send"
This button sends the frame entered previously to the Characters section to be
sent.
• Button: "Continuous"
This button sends continuously the frame entered previously to the Data section
to be sent.
• Button: "Initialization"
This button reinitializes all the counter fields (Elapse Time, Character Count,
Frame Count, etc.)
• Button: "Stop"
This button stops a continuous upload.
• Button: "Quit"
This button leaves this window and returns to the main menu.
• "Character Count Sent/Received" Fields
These fields show the sizes of the sent and received frames.
• "Elapsed time" Field
This field shows how long it takes the modem to upload the same frame during a
continuous upload.
• "Sent/Received/Corrupted Count" Fields
These fields show the amount of frames correctly uploaded, downloaded or
corrupted (or not received) since the start of a continuous upload.
• "Stop on Error" Selection
This selection stops automatically the continuous upload if a frame is corrupted.