User's Manual
Table Of Contents
- Objective
- Module introduction
- Basic Operation
- General
- "Hayes" Mode
- "Point-to-Point" Mode
- "Network" Mode
- Demo Kit Utilization
- Installation and Connection
- WinB900 Software Utilization in Point-to-Point Mode
- The different fields and buttons are described below:
- "Sent Characters" Field
- "Received Characters" Field
- "Test Frames" Selection
- "Characters Count" Field
- Button: "Send"
- Button: "Continuous"
- Button: "Initialization"
- Button: "Stop"
- Button: "Quit"
- "Character Count Sent/Received" Fields
- "Elapsed time" Field
- "Sent/Received/Corrupted Count" Fields
- "Stop on Error" Selection
- Use of the WinB900 Software in Network Mode
- Use of the "Terminal" or "HyperTerminal" Software
- Advanced Operation
- Appendix 1: Schematic Block Diagram
- Appendix 2: Mechanical Drawings
- Appendix 3: Antenna Connection
- A
- Appendix 5: Timing Diagrams
- Appendix 6: Description of the registers
- Appendix 7: Revisions History
16
Consequently, you can communicate between the two Modems with the ‘Point-to-
Point Dialogue’ Option from the "Quick Configuration" menu. When this option is
selected, the software displays the following screen:
The different fields and buttons are described below:
• "Sent Characters" Field
This side of the window sends the data entry.
• "Received Characters" Field
This side of the window shows the received data.
• "Test Frames" Selection
This selection allows the selection for the type of character sent. For example,
0x00 sends a character frame only made of a 0x00 binary character.
If the "Free" frame type is selected, the frame can be typed by the user in the
"Sent Character" field. This frame will then be sent.