User's Manual
Table Of Contents
- Objective
- Module introduction
- Basic Operation
- General
- "Hayes" Mode
- "Point-to-Point" Mode
- "Network" Mode
- Demo Kit Utilization
- Installation and Connection
- WinB900 Software Utilization in Point-to-Point Mode
- The different fields and buttons are described below:
- "Sent Characters" Field
- "Received Characters" Field
- "Test Frames" Selection
- "Characters Count" Field
- Button: "Send"
- Button: "Continuous"
- Button: "Initialization"
- Button: "Stop"
- Button: "Quit"
- "Character Count Sent/Received" Fields
- "Elapsed time" Field
- "Sent/Received/Corrupted Count" Fields
- "Stop on Error" Selection
- Use of the WinB900 Software in Network Mode
- Use of the "Terminal" or "HyperTerminal" Software
- Advanced Operation
- Appendix 1: Schematic Block Diagram
- Appendix 2: Mechanical Drawings
- Appendix 3: Antenna Connection
- A
- Appendix 5: Timing Diagrams
- Appendix 6: Description of the registers
- Appendix 7: Revisions History
10
2.3. Available Configuration
2.3.1. Software Configuration
The B900ss-20 has 3 operating modes managed by the WinB900 Software (See Chapter
3):
• "Hayes".
• Point-to-Point.
• Network (future)
2.3.2. Hardware Configuration
All the B900SS product radio modules are delivered with the necessary software for
operation. An evaluation Demo Kit (D900SS-20) is available at Adcon and allows the
user to evaluate the radio module's performance. For more information, refer to
Appendix 4.
With each radio module, the following is available:
• Series of programming ASCII messages to integrate the radio modems with a serial
link.
• A Windows configuration and test software programming the radio modules and
testing the links (quality, distance, shadow area, etc.).
• A set of reference material available in CD-ROM.