Technical Manual
Table Of Contents
- Wireless Sensor Interface A720 (addIT™)
- 1. About the A720
- 2. Hardware
- 4. Software
- 4.1. AMOS
- 4.2. Mode Check
- 4.3. A/D Task
- 4.4. The Terminal Task
- 4.5. The Radio Interface Task
- 4.5.1. Digital Squelch
- 4.5.2. Modulation Technique Used
- 4.5.3. Generic Format of a Radio Frame
- 4.5.4. Data Frames
- 4.5.5. Frame Types
- 4.5.5.1. Request
- 4.5.5.2. Broadcast Answer
- 4.5.5.3. Set I/O Request
- 4.5.5.4. Read I/O Answer
- 4.5.5.5. Broadcast Request
- 4.5.5.6. Ping
- 4.5.5.7. Pong
- 4.5.5.8. Memory Dump Request
- 4.5.5.9. Memory Dump Answer
- 4.5.5.10. Data
- 4.5.5.11. Set ID
- 4.5.5.12. Set Slot Time and Sample Rate
- 4.5.5.13. Set Frequency
- 4.5.5.14. Set Battery Charge Levels
- 4.5.5.15. Set Pulse Counters Parameters
- 4.5.5.16. General Acknowledge
22
Wireless Sensor Interface A720 (addIT™)
Several graphs obtained by means of a Rohde & Schwarz Spectrum Analyzer (model
FSEA) are attached, reflecting some of the measured parameters.
Figure 6. Spurious radiations (Marker 2); except the second harmonic, no other overtones
are visible.
Figure 7. Adjacent Channel Power, 460 MHz, 12.5 kHz version, modulated with a 0x55
tone (1500 bps).