User Guide

| ADCOM GDV-850 Owner’s Manual8
9ADCOM GDV-850 Owner’s Manual |
cable is used to make the connection to
the GDV-850. Refer to section 2.3 for
more detail.
[
17
]
Analog Audio Output
Using the analog audio output allows
the internal DSP and DACs to decode
and convert the data from the disc to
analog signals. This output is used when
connecting the player to an analog stereo
preamp, and is necessary for use in many
distributed audio setups. This output
can also make use of analog direct
modes available on many preamplifiers
like ADCOM’s GTP-880.
[
18
]
5.1 Audio Output
To enjoy the high resolution playback
of multichannel DVD-Audio discs,
connect these six RCA jacks to the 5.1
analog inputs on your preamplifier or
receiver. Use six separate RCA cables
to make the connection to your pre-
amp. Due to copy protection issues,
the digital output may need to be off
during playback of DVD-Audio discs.
[
19
]
Digital Audio Output
Dolby Digital and DTS movie sound
tracks will be sent to your preampli-
fier via the digital audio output. Your
preamplifier must be able to decode
Dolby Digital and/or DTS digital sig-
nals. Otherwise, you will need to use
the GDV-850’s 5.1 analog outputs to
enjoy Dolby Digital and DTS sound.
[
20
]
12V DC Trigger
A trigger, if properly hooked-up, can prove
to be very convenient. Use the 12V DC
trigger in conjunction with your preamp
to turn the player on and off. The trigger
output from your preamp should go in to
the trigger input on the rear panel of the
GDV-850. A pass-through output jack is
provided to allow trigger control of ad-
ditional components in your system.
[
21
]
IR Input
Use the IR input jack to connect an
external IR sensor to the GDV-850
when the unit is installed behind doors
or where it is not otherwise visible to
the remote.
[
22
]
Voltage Switch
Before plugging the unit in make sure
the voltage is set to your country’s
voltage configuration. The GDV-850
should be unplugged prior to flipping
this switch. If you are uncertain, please
have your installer or dealer verify
before proceeding.
[
23
]
Main AC Power Switch
Turns the current to the GDV-850 on
or off. Setting this button to the on
position supplies power to the unit,
enabling use of the standby power
button on the front panel. When the
main power switch is in the off posi-
tion, current is cut off to the unit.
[
24
]
IEC AC Input
Use to connect the supplied IEC re-
movable AC power cord (see page 2
for all warnings). Before proceeding,
please observe the following precau-
tions when connecting devices to your
new GDV-850.
Do not plug the power cord into your
GDV-850 until all other connections
have been made.
Insert the supplied power cord into
the AC input of the rear panel of the
GDV-850. Do not use a power cord
other than the one supplied with the
GDV-850. It’s designed for use with the
GDV-850 and should not be used with
any other device.
Caution: Before you plug the power cord
into an AC wall outlet, confirm that all
connections to the GDV-850 have been
made correctly.
Warning: Never disconnect the power cord
from the GDV-850 while the other end is
plugged into an AC outlet. Doing so may
cause an electric shock. Always connect
power by plugging into the AC outlet last
and disconnect by unplugging from the AC
outlet first.