Datasheet

Electrical characteristics ST7LITE20F2 ST7LITE25F2 ST7LITE29F2
118/170 DocID8349 Rev 7
13 Electrical characteristics
13.1 Parameter conditions
Unless otherwise specified, all voltages are referred to V
SS
.
13.1.1 Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
A
=25°C and T
A
=T
A
max (given by the
selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
13.1.2 Typical values
Unless otherwise specified, typical data are based on T
A
=25 °C, V
DD
=5 V (for the
4.5V≤ V
DD
≤ 5.5 V voltage range) and V
DD
=3.3 V (for the 3 V≤ V
DD
≤ 4 V voltage range). They
are given only as design guidelines and are not tested.
13.1.3 Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
13.1.4 Loading capacitor
The loading conditions used for pin parameter measurement are shown in Figure 50.
Figure 50. Pin loading conditions
13.1.5 Pin input voltage
The input voltage measurement on a pin of the device is described in Figure 51.
C
L
ST7 PIN