User`s manual

BURNER PURGE FAULT - The gas valve signal is present during the prepurge time.

MODEL ERROR, ENTER CORRECT MODEL - The wrong model was selected for the dryer.

EE PROM FAULT ### - Error in memory location. The ### indicates the location of the fault.

B. INPUT/OUTPUT (I/O) BOARD LIGHT EMITTING DIODE (L.E.D.)

INDICATORS

1. INPUTS

1. ESTOP – (RED L.E.D.) This L.E.D. will indicate the status of the E-STOP. If the E-STOP has been

pressed, then the L.E.D. is ON.

2. GAS_V – (RED L.E.D.) This L.E.D. will indicate the status of the gas valve. If the gas valve is open

(ON), then the L.E.D. is ON.

3. BRHL – (RED L.E.D.) This L.E.D. will indicate the status of the burner high limit disk. If the disk is

closed (temperature below 330º F [166º C]), then the L.E.D. is ON.

4. SAIL – (RED L.E.D.) This L.E.D. will indicate the status of the sail switch. If the switch is closed, then

the L.E.D. is ON.

5. EXHL – (RED L.E.D.) This L.E.D. will indicate the status of the exhaust high limit disk. If the disk is

closed (temperature below 225º F [107º C]), then the L.E.D. is ON.

6. MAIN – (RED L.E.D.) This L.E.D. will indicate the status of the main door. If the door is closed, then

the L.E.D. is ON.

7. LINT – (RED L.E.D.) This L.E.D. will indicate the status of the lint drawer. If the drawer is closed,

then the L.E.D. is ON.

8. FUSE – (RED L.E.D.) This L.E.D. will indicate the status of the control voltage. If the POWER ON

button is pressed (green button light is on), then the L.E.D. is ON.