User guide

Demo kit Hardware Configuration
6-4 EV10AQ190x-DK - User Guide
1067BX–BDC–12/11
e2v semiconductors SAS 2011
6.4 SYNC Signal The SYNC signal is controlled by the FX2 microcontroller, but it could also be controlled
by the FPGA.
The selection between the two clocks is done manually with a resistor.
Note: e2v doesn't provide the SYNC signal FPGA code.
Remove R105 resistor and solder R106 with a 0.
Figure 6-6. SYNC Schematic
Figure 6-7. Implantation of R105 and R106 Resistors
BOTTOM VIEW