User guide

Software Tools
EV10AQ190x-DK - User Guide 4-1
1067BX–BDC–12/11
Section 4
Software Tools
4.1 Overview The Demo Kit board needs three different kinds of software tools:
FPGA software
The Demo Kit board can be plugged with XILINX VIRTEX 6 evaluation board EK-V6-
ML605-G
http://www.xilinx.com/products/devkits/EK-V6-ML605-G.htm
e2v provides FPGA program to be used with Quad 10-bit Demo Kit.
User Interface software
The User Interface software is a Visual C++ compiled graphical interface that does not
require a licence to run on a Windows NT or Windows 2000/98/XP PC and windows7
(32 bit)
The software uses intuitive push-buttons and pop-up menus to write data from the
hardware.
Display Software
The User Display software is Labview software that does not require a licence to run on
a Windows NT or Windows 2000/98/XP PC and Windows 7 (32bit)
The software uses intuitive push-buttons and pop-up menus to write data from the
hardware.
Warning: For the software installation, administrative rights are needed.
Warning: If the software is already installed a window appears.
Figure 4-1. Error Message if Labview Software is Already Installed
This applies when a previous version of software is present or a version of the Quad8 bit
demo is present. When updating an installation it is recommended to uninstall the exist-
ing version (but not DK_DBC_Processing&Display).
If an other demo kit software, e.g. the DK-Quad8, is installed this can be left in place.
Click on OK and continue.