User guide

Quick Start
2-2 EV10AQ190x-DK - User Guide
1067BX–BDC–12/11
e2v semiconductors SAS 2011
Figure 2-1. USB Port Driver Configuration
Warning: this installation is done for one USB connector only. If USB connector is
changed, USB driver need to be re-installed before use.
2.2.2 Start up Procedure  Check that supplies are properly powered on and properly connected.
 Check if the Xilinx FPGA evaluation board ML605 is properly configured with correct
software.
 Check if QUAD 10-bit Demo Kit is properly plugged into FPGA connector.
 Check if USB connector is properly plugged.
2.2.3 Measurement  Check if QUAD 10-bit ADC is properly configured in normal mode without standby
and test mode.
Note: check if currents are correct (see Section 4.5.5 Power)
Note: check if test mode is OFF (see Section 4.5.2 TEST)
 Check if acquisition mode is correctly configured.
 Warning: if no windowing is used or if signal is non coherent, FFT of Figure 6 is
obtained