Technical information

C:
\
UFFICIO T
ECNICO
\
MANUALI
\
ML2
00
\
ML200 INGLESE
\
67
APPENDIX 1
TRASFORMATION CONVERTER FROM COMPACT VERSION TO
SEPARATE VERSION
2
ISOIL
Connection box section
1 2 3 4 5 6 7 8 9 10
11 12 13 14 15 16 17 18 19 20
Cover
Power supply
- Disconnect the cable from terminal - Unthread the cables from converter
ISOIL
O-Ring
Grower Ø 6
6 MA nuts
- Uncrew the 6MA nuts and remuve the fixing plate for compact version
Rear converter
ISOIL
Fixing plate
O-Ring 2056
- Assemble the fixing plate for separate version like in picture aside
Grower Ø 6
ISOIL
Fixing screw (tighten strongly)
Wall bracket
Fixing flie
- Tighten the fixing screw - Screw the fixing flie
Nut of cable gland
Coil connector (2 cable)
Electrode connector (3 cavi)
- Insert the connectors in the connectors assemblate to the connectors plate - Insert the cables in the connectors box and tighten nuts and cable gland
O-RING 155
cover of connection box
- Remuve the corcks
3
- Insert the cable in the connector box like in picture aside
- Insert the l'O-Ring in the appropriate seating - Assemble the cover to the connection box by screwing the fixing screw
4 5 6
- Make the electric connections following the indication listed in section: "Electrical connection" of meter operative manual
- Remuve the fixing screw and separate the sensor from converter by remuving the connectors
1
6 MA nuts