Technical information

C:
\
UFFICIO T
ECNICO
\
MANUALI
\
ML2
00
\
ML200 INGLESE
\
59
(POS. 58) Flow rate simulation enable [SIMULATION]
Flow rate simulation enable. With this function it is possible to enable the function generating an internal signal
applied on the input terminals simulating the flow rate, allowing the outputs test and all the instruments connected.
After enable the simulation flow rate it could be:
- set: pushing for more 1 second the key from one of four visualization pages
- start: pushing the key after set it
- finished: pushing for more 1 second the key from visualization pages and then pushing for more 1 second the
key .
N.B.: the enable of flow rate simulation disable the contrast regulation with the key (Pos. 51) and yhe access to
main menu.
MENU 11.INTERNAL DATA
(POS. 59) Level 2 access code set [L2 KEYCODE= XXXXX]
Level 2 access code enter. This code is programmable by the user within the range 00001 - 65535. Setting such a
value at 22222 the access code for levels lower than level 3 is disabled. (see pag.33)
(POS. 60) Block level [BLOCK LEVEL =X]
Block level function can be set from 0 to 3. Every level enables and disables the use of specific functions (see pag.34).
N.B.: the block levels are enabled only if the dip-switches on the back of converter are on (turn on the small levels
towards the symbol of the padlock)