Technical information

C:
\
UFFICIO TECNICO
\
MANUALI
\
ML2
00
\
ML200 INGLESE
\
37
5 E.P. DETECT 6 AUTOZERO CAL. 7 E.P. CALIBR.
ON/OFF START AUTOZERO CALIBRATION START EMPTY PIPE CALIBRATION
ENABLE/DISABLE EMPTY PIPE TEST
12 TPUL1 13 14 FRQ1 15 FRQ2 16 SW
DURATION OF THE PULSE CHANNEL 1 FULL SCALE FREQUENCY SET CHAN. 1
ACTIVE IF CHANNEL 2 IS ON PULSE ACTIVE IF CHANNEL 1 IS ON FREQUENCY
SPECIFIC GRAVITY SET
ACTIVE IF MASS UNIT HAS BEEN SELECTED
21 AUTOCAL.
ENAB./DISAB THE AUTOCALIB FUNCTION
22 ATORANGE
ENAB./DISAB. THE AUTOMATIC CHANGE OF SCALE
28 mA VAL.FAULT
4/20 mA CURRENT ALARM SET
29 Hz VAL.FAULT
FREQUENCY OUTPUT ALARM SET
ONLY IF CHANNEL 1 OR 2 IN FREQUENCY MODE
23 E. SAVING
AUTAMATIC ENERGY SAVING FUNCTION ENABLE
34 COUNT LOCK
LOCK TOTALISER
35 CALIBRATION
AUTOZERO CALIBR. EXTERNAL COMMAND ENAB.
36 RANGE CHANGE
RANGE CHANGE EXTERNAL COMMAND ENAB.
37 BATCH
BATCH START/STOP EXTERNAL COMMAND ENABLE
FUNCTION ACTIVE WITH INPUT IN VOLTAGE
42 OUT.mA1
CHOOSE CURRENT VALUE OUTPU 1
43 OUT.mA2 (OPT.)
START/END RANGE (0/4-20/22 mA) AND FIELD (+,-,±,-0+)
56 CLEAR DATA
LOGGED DATA CANCEL FUNCTION
63 SAVE USER PRES.
DURATION OF THE PULSE CHANNEL 2
TPUL2
FULL SCALE FREQUENCY SET CHAN. 2
ACTIVE IF CHANNEL 2 IS ON FREQUENCY
CHOOSE CURRENT VALUE OUTPU 2
USER VALUE SAVE
ML 200
KEYCODE LEVEL
The opportune selection of the channel 1 and 2,
allows to be on the 2 output on/off 2 separate
signals of volume and/or frequency
Some of the functions above suitable are visualised
on the display only with the qualification of other
functions or with the insertion of additional modules
(sees details in the following chapters)