Technical information

C:
\
UFFICIO TECNICO
\
MANUALI
\
ML2
00
\
ML200 INGLESE
\
12
MS 3770 Assemble Instructions
Flow direction
Z
weld the jacket to the pipe line
- Introduce in the sensor the gasket - Introduce the sensor in the Jacket Ø 1"
- Line up longitudinally the connector box with pipe line axle (pic.6). - Tighten the nut with spanner (pic. 5) maintaining the alignment. The fixing of nut must assure the seal of the inside gasket
Pic. 1
Pic. 2
Pic. 3
Pic. 4
Pic. 5
Pic. 6
Jacket Ø 1"
Pipe line
Sensor Gasket
Jacket Ø 1"
Pipe line
Spanner 40mm
z
Over-metal
Cut the jacket Ø 1" like in picture 1 ATTENTIONE: in relation to the Ø of the pipeline consider the necessary over-metal for welding