Technical information

C:
\
UFFICIO TECNICO
\
MANUALI
\
ML2
00
\
ML200 INGLESE
\
10
- Weld to the pipeline a pipe Ø 1". ATTENTION: verify "X" dimension (pic. 2).
Pic. 1
Pipe Ø 1"
Pipe line
Spanner 40mm
Screw the valve Ø 1" to the welded pipe
X
Xmax=140mm
- Screw the 1" jacket to the valve ATTENTION: the O-Ring in the jacket must be place underside (near valve)
Inferior estremity of the jacket (O-Ring seal)
- Insert the sensor at close valve - Tighten the fixing nut with spanner (pic. 6)
- Open the valve - Screw the sensor up to "Z" dimension - Verify the line up (pic. 9) - Tighten the block nut manteining the aligment
flow
direction
Pic. 2
Pic. 3
Pic. 4
Pic. 5
Pic. 6
Pic. 7
Pic. 8
Pic. 9
Z
Block nut
N.B.: Le maniglie di inserimento del sensore sono removibili
sensor handles
1 2 3
4 5
Fixing nut
Fixing nut
MS 3700 Assemble Instructions