Specifications

ST72325xx
196/197
16 REVISION HISTORY
Table 33. Revision History
Date Revision Description of Changes
26-Sep-2005 1 Initial release
04-Dec-2006 2
Modified LQFP48 pinout, added S device ordering information
Modified Note 4 on page 16 for unbonded pins in 48 pin C devices
Added caution about reset vector in unprogrammed Flash devices in Section 6.3.
Removed EMC protective circuitry in Figure 88 on page 163 (device works correctly without
these components)
Modified SS
min. setup time and added note 4 to section 12.11.1 on page 166
Modifed description PKG1 bit in “FLASH OPTION BYTES” on page 181
Added “TIMD set simultaneously with OC interrupt” on page 194
04-Apr-2007 3
In Table 2 added note 5 for I/O Port E2 (PE2) output mode “pull-up always activated” and
added note 6 on connection of power and ground pins.
Deleted the sentence in Section 4.3.1 ‘Readout protection is not supported if LVD is enabled
Added Package dimensions for LQFP64 14 x14 in Figure 122
Specified EMI data for LQFP64 in Section 12.7.2
Added ‘Pull-up always active on PE2’ in Section 15.1.8
07-Oct-2008 4
Title of the document changed
Modified Table 1 on page 1
Modified “Starting the Conversion” on page 133
Modified t
RET
and N
RW
values in “FLASH Memory” on page 155
Modified “Absolute Maximum Ratings (Electrical Sensitivity)” on page 158
Values in inches rounded to 4 decimal digits (instead of 3) in “PACKAGE MECHANICAL DA-
TA” on page 174
Removed reference to “Application with a Crystal or Ceramic Resonator for ROM (LQFP64
or any 48/60K ROM)” on page 151
Modified “PACKAGE CHARACTERISTICS” on page 174 (Section 13.3)
Modified “TIMD set simultaneously with OC interrupt” on page 194
Modified Section 14.2 DEVICE ORDERING INFORMATION AND TRANSFER OF CUS-
TOMER CODE on page 183 (Figure 106 and option lists)