Technical information

Cuda 12000 IP Access Switch CudaView Administration Guide
Tools from the Tools Menu 71
Modem Configuration — Allows you to configure trace log information to
view and monitor cable modem-specific data on a per interface basis. Select
the Interfaces tab and choose the interface.
■ CM Trace Log Config — You can configure trace log information to view
and monitor information as it pertains to the registration of a single cable
modem. This allows you to view and monitor the information flow that
occurs during a registration of a specific cable modem. Use this
information to debug registration failures on a per cable modem basis. To
configure trace log for a cable modem, perform these GUI operations in
any order:
■ Specify the MAC address of the cable modem that you want to
monitor.
■ Choose the detail level at which you want to monitor the specified
information. The options are low, medium, high, and highest.
■ Select whether you want to monitor the cable modem registration
messages.
■ Select whether you want to monitor cable ranging messages.
■ Select whether you want to monitor cable modem baseline privacy
messages.
ppp-debug- Events related the LCP and
IPCP messages used to establish the PPP
link.
ppp - Events related the state of the PPP con-
nection.
courier- Not supported. ospf-spf - Not supported.
ospf-hello - Not supported. nlbg - Events related to establishing the net
layer bridge flow.
nlbg-rs - Distributes information to all
modules regarding the nlbg interfaces.
nlbg-cmts - Enables tracking for nlbg database
reception. Developer debug only.
RIP_STATE - Events related to internal RIP
states.
RIP_GENERAL - Miscellaneous RIP events.