Technical information

Cuda 12000 IP Access Switch CudaView Administration Guide
Viewing Classifiers 605
Viewing the Service Flows Log
To view the Service Flow log, follow this procedure:
1. In the Summary window, select the flow for which you wish to configure
QoS. Refer to Table 20-12.
2. Click the Log tab. The Log window appears. Refer to Table 20-18.
3. Click Refresh to update the information.
What You See
This figure shows an example of the Log window.
Size (PHSS) Number of bytes in the heater to be suppressed and
restored.
Verify (PHSM) Payload header suppression verification value. If true,
the sender must verify that the Field parameter is the
same as what is contained in the packet to be
suppressed.
Index Unique index for the PHS rule on a given Service Flow.
Field Defines the bytes of the header that must be
suppressed/restored by the sending/receiving device.
Mask Defines the bit mask and when combined with the
Field parameter, defines which bytes in the header
must be suppressed/restored by the sending or
receiving device.
A bit value of one indicates the byte should be
suppressed by the sending device and restored by the
receiving device. A bit value of zero indicates the byte
should not be suppressed by the sending device or
restored by the receiving device.
Table 20-17 PHS Window Parameters (continued)
Parameter Description