Technical information

ADC Telecommunications, Inc.
370 C
HAPTER 13: CREATING ROUTE FILTERS
Modifying OSPF Import ACEs
Modifying an OSPF Import ACE involves removing the ACE from an ACL
within the ACL configuration window, and deleting it as an ACE within the
ACE configuration window. To modify an OSPF import filter, follow this
procedure:
Note: Before an ACE is modified, it must first be removed from each
ACL of which that ACE is a member.
1. In the Import Filters window, click the ACL tab. The ACL window appears
(Figure 13-4, “RIP/OSPF Import Filters ACL Window”).
2. From the Filters column, select the ACL or the row that includes the ACE
you wish to modify. Click Modify.
3. From the Templates for filter section, select the ACE and using the
arrows, move it back to the Pools of all templates section.
4. Click Ok to commit or click Cancel to exit.
5. Click the ACE tab.
6. Select the row that includes the ACE that you wish to modify. Click
Modify.
7. Modify parameters as necessary.
8. Click Ok to commit or click Cancel to exit.
Peer Range
Mask
Network mask for the peer IP address sending incoming
packets. You can match on a single peer IP address or match
on all peers from a range.
For example, to match on a single peer enter the peer’s IP
address, and enter the network mask of 255.255.255.255
To match on all peers from a range enter 1.1.0.0, and enter
the network mask of 255.255.0.0.
Preference If a match is found and the Import action is Enabled, then use
this preference when this route is added to the routing
database. Acceptable values are 0-255.
Parameter Description