Technical information

ADC Telecommunications, Inc.
348 C
HAPTER 12: CONFIGURING IP ROUTING
Configuring OSPF Virtual Interfaces
TOSPF requires that all areas be attached to the OSPF backbone area (area
0.0.0.0). However, you may encounter situations in which you cannot
connect an OSPF area directly to the backbone. If your Cuda 12000 is an
area border router between one area that is physically connected to the
OSPF backbone and one area that is not, you can create a virtual interface on
your Cuda 12000 to connect the non-contiguous area to the OSPF
backbone.
Before You Begin
Before you configure the OSPF virtual interfaces, follow this procedure:
1. Navigate to Network Browser > GroupName > ChassisName > Cuda
Chassis Manager > Configuration > IP > IP Routing.
2. Click the OSPF Global tab.
3. Click the Virtual Interfaces tab.
4. Click the Virtual Interfaces sub tab.
What You See
Figure 12-23 OSPF Virtual Interfaces Window