Technical information

ADC Telecommunications, Inc.
324 C
HAPTER 12: CONFIGURING IP ROUTING
Adding a RIP Neighbor
To add a RIP neighbor, follow this procedure:
1. In the RIP Global window, click the Neighbors tab.
2. Click Add. The Add RIP Neighbor window appears.
3. Enter values for the parameters. Refer to Table 12-8.
4. Click Ok to commit or click Cancel to exit without saving.
Note: You must have configured at least one RIP interface first.
What You See
Figure 12-12 Add RIP Neighbor Window
Neighbor IP
Address
IP address of the neighbor.
Type A neighbor is of type Configured if it is configured on the
interface. A neighbor is of type Discovered (discovered
dynamically) if it is not configured, and updates from this
neighbor are received on this interface.
Last Update Time since last update was received from this neighbor.
Read-only.
Parameter Description