Technical information

Cuda 12000 IP Access Switch CudaView Administration Guide
Configuring RIP Global 319
Adding a RIP Interface
Configuring a RIP interface involves adding RIP over an interface. After RIP is
added to the interface the Cuda 12000 begins to exchange RIP routes with
adjacent RIP routers. To configure RIP interface, follow this procedure:
1. In the RIP Global window, click the RIP Interfaces tab.
2. Select the row that includes the interface over which you wish to add a
RIP interface.
3. Click Add. The Add RIP Interface window appears.
4. Enter values for the parameters. Refer to Table 12-6.
5. Click OK to commit the information or click Cancel.
Send Indicates which version of RIP packets this router sends on
this interface. The options are: RIPv1, RIPv2, RIPv1
compatible, or none.
RIPv2 Sends routes over a multicast IP address.
RIPv1 Compatible sends routes as RIPv2, however, over a broadcast
IP address
Receive Indicates which versions of RIP packets the router accepts on
this interface. You may choose from RIPv1, RIPv2, both or
none.
cost Indicates the metric value that is to be added to the route
metric of the routes advertised through this RIP interface.
Parameter Description