Technical information

Cuda 12000 IP Access Switch CudaView Administration Guide
Configuring IP Source Routing 315
■ Next Hop Gateway. The IP address to which the system must forward
any matching IP datagrams. Note that you must enter a valid next hop
destination.
Adding a Source Route
Source routing is defined on a per-interface basis. To add a source route
entry on a particular interface, follow this procedure:
1. Navigate to Network Browser > GroupName > ChassisName > Cuda
Chassis Manager > Configuration > IP > IP Routing.
2. Click the IP Configuration tab.
3. Click the IP Configuration sub tab.
4. Select the row that includes the interface on which you want to add an IP
source route.
5. Click the IP Source Route tab. The IP Source Route window opens and
includes all source route entries configured on the interface.
6. Click Add to add an IP source route. The Add IP Source Route window
opens as shown in the next figure.
7. Enter values for the parameters.
8. Click OK to commit the information or click Cancel to exit without
saving.