Technical information

Cuda 12000 IP Access Switch CudaView Administration Guide
Alarm Tables 273
Alarm Tables
The Alarm Table allows you to view all the alarm notifications (sent in the
form of SNMP Traps and syslog messages) that the management module
receives. It also allows you to update the status of Traps as you address them,
and purge (delete) traps when you no longer need them. There are three
Alarm Table views, as follows:
■ Chassis View — Display the Alarm Table for the entire chassis. You can
only display the chassis view from the Views folder.
■ Card View — Display the Alarm Table for only a module. You can only
display the chassis view from the Views folder.
■ Alarm Log View — Displays the Alarm log for all modules and software.
You can only display the chassis view from the Alarm Log folder.
Alarms are displayed only during client runtime. There is no alarm history.
Before You Begin
Before you begin to view the alarm tables, navigate to Network Browser >
GroupName > ChassisName > Cuda Chassis Manager > Fault
Management.
Viewing Module and Chassis Faults
To view the Card and Chassis Alarm Tables use these procedures:
1. From the Fault Management folder, navigate to Views > Universal
View.
2. Open the Universal View folder, and double-click on the graphic of the
chassis to display the maximized chassis view.
3. To display the Alarm Table for a selected module, double-click on the
desired module to display an Alarm Table. The alarm table for the
selected module appears (Figure 11-4.)
4. To display the Alarm Table by Chassis View, double-click on the left or
right view of the mounting bracket of the chassis. The alarm table for the
chassis appears (Figure 11-5).