Technical information
Cuda 12000 IP Access Switch CudaView Administration Guide
Document Organization 23
■ Part III: IP Routing
■ Chapter 12: Configuring IP Routing — Provides information and
procedures for configuring IP interfaces and routing protocols,
including RIP and OSPF. Also includes information on adding static IP
routes and configuring DHCP relay agents.
■ Chapter 13: IP Packet Filtering — Allows you to restrict and control
IP packet flow over specified cable interfaces. This control of IP packet
transmission restricts network access from specified users, devices,
and applications.
■ Chapter 14: Network-Layer Bridging — Allows a single subnet to
span across multiple DOCSIS CMTS modules. NLBG allows you to add
the same IP address to multiple physical interfaces throughout the
system.
■ Chapter 15: Creating Route Filters — Provides information and
procedures for creating RIP and OSPF policy-based route filters.
■ Chapter 16: Configuring DHCP Relay — Provides information and
procedures for configuring DHCP Relay on CMTS interfaces.
■ Chapter 17: IP Multicast — Allows you to reduces traffic on a
network by delivering a single stream of information to multiple users
at one time.
■ Part IV: Cable Modem Termination Systems
■ Chapter 18: Configuring Cable Modem Termination Systems
(CMTS) — Provides information and procedures for configuring and
managing CMTS RF parameters. Provides instruction on the
configuration of downstream and upstream channels and advanced
CMTS parameters.
■ Chapter 19: Configuring BPI Plus Certificates — Describes how to
configure DOCSIS 1.1 BPI+ certificates.
■ Chapter 20: Managing Cable Modems — Provides information for
monitoring and managing cable modem (CM/MTA) activity on the
network.
■ Chapter 21: Configuring Subscriber Management — Describes
how to configure subscriber traffic filtering for cable modems and
Customer Premise Equipment (CPE) devices.
■ Chapter 22: Browsing MIBs — Provides information on how to
browse cable modem and MTA MIBs, and the MIB objects that are
returned.