Technical information

ADC Telecommunications, Inc.
224 C
HAPTER 9: MODULE ADMINISTRATION
Configuring Gigabit Ethernet Duplex Mode
The Cuda 12000 allows you to configure duplex mode on the Gigabit
module.
You may set duplex mode to full duplex, half duplex, or auto negotiation. By
default, the Cuda 12000 sets duplex mode to auto negotiation.
To configure duplex mode on the Gigabit module, follow this procedure:
1. Navigate to the Gigabit folder.
2. Click the Summary tab. The Interface Summary window appears. (Refer
to Figure 9-10.).
3. Select the row that includes the module that you want to configure.
4. Click the Configuration tab. The Configuration window appears.
5. Disable Auto-negotiation. If Auto-negotiation is enabled, a check-mark
appears in the Auto-negotiation field.
6. Select the duplex mode that you want to configure for the specific
module. (Refer to Table 9-14.)
7. Click Apply to commit the changes;, or click Reset to return to the
original configuration.