Technical information

Cuda 12000 IP Access Switch CudaView Administration Guide
Configuring 10/100 Ethernet Duplex Mode and Speed 215
Configuring 10/100 Ethernet Duplex Mode and Speed
The Cuda 12000 allows you to configure duplex mode and speed on the
10/100 module.
You may set duplex mode to full duplex, half duplex, or auto negotiation.
You may set the speed to 10 Mpbs, 100 Mbps, or auto negotiation. By
default, the Cuda 12000 sets duplex mode and speed to auto negotiation.
To configure duplex mode and speed on the 10/100 module, follow this
procedure:
1. Navigate to the 10/100 folder.
2. Click the Summary tab. The Interface Summary window appears. (Refer
to Figure 9-7.).
3. Select the row that includes the module that you want to configure.
4. Click the Configuration tab. The Configuration window appears.
5. Disable Auto-negotiation. If Auto-negotiation is enabled, a check-mark
appears in the Auto-negotiation field.
6. Select the speed and duplex mode that you want to configure for the
specific module. (Refer to Table 9-10.)
7. Click Apply to commit the changes;, or click Reset to return to the
original configuration.